Brother International TD-4750TNWB FBPL Command Reference - Page 219

11.21 GETSETTING$() Description Obtain the printer configurations. Syntax GETSETTING$(app$,sec$,key$[,default$]) app$ SYSTEM FILE CONFIG sec$ INFORMATION RECORD DRAM FLASH CARD NET WLAN COM1 SENSOR FBPL key$ DPI MODEL SERIAL VERSION CHECKSUM PRINTQUALITY STANDBYTIME MILAGE LABEL COUNTER CUT COUNTER CAPACITY AVAILABLE CAPACITY AVAILABLE CAPACITY AVAILABLE INSTALLED MAC ADDRESS IP ADDRESS SUBNET MASK DEFAULT GATEWAY RAW PORT NAME PRIMARY DNS SECONDARY DNS MAC ADDRESS IP ADDRESS SUBNET MASK DEFAULT GATEWAY RAW PORT BAUD RATE DATA BIT PARITY STOP BIT SENSOR TYPE CARRIAGE GAP INTENSION BLINE INTENSION CONTINUOUS INTENSION PRINT MODE DENSITY PAPER SIZE GAP SIZE BLINE SIZE DIRECTION MIRROR RIBBON REPRINT PAPER WIDTH LIMIT FEED 214 Comment Resolution Model name Serial number Firmware version Firmware checksum Print mode (DRAFT, STANDARD or OPTIMUM; see SET PRINTQUALITY) For RJ-2035B/2055WB/3035B/3055WB only Printer standby time (OFF or number) For RJ-2035B/2055WB/3035B/3055WB only Printed mileage (in dots) Total number of prints Cutting counter Total capacity of DRAM Available capacity of DRAM Total capacity of FLASH Available capacity of FLASH Total capacity of CARD Available capacity of CARD Status of card. 1: installed; 0: none installed. MAC address IP address Subnet Mask Default gateway Raw port Printer name Primary DNS Secondary DNS MAC address IP address Subnet Mask Default gateway Raw port Baud rate of COM port Data bit of COM port Parity of COM port Stop bit of COM port Current sensor type Status of head open sensor Intension of gap sensor Intension of black mark sensor Intension of continuous sensor Post-print action Print density Paper size Gap size Black mark size Printing direction Mirror status Ribbon status Reprint status Paper width Maximum length for sensor calibration.