Brother International VX-810 Users Manual - English - Page 30
Monogramming, Embroidering, Using, Embroidery
View all Brother International VX-810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Monogramming and Embroidering, Using Embroidery Hoop STITCH LENGTH STITCH WIDTH NEEDLE POSITION PRESSER FOOT NEEDLE PRESSURE ADJUSTER OTHERS Set at any position : 0- 5 M : Removed : Single : Up : Darning Plate PREPARATION FOR MONOGRAMMING AND EMBROIDERING 1. Set your sewing machine as per above instructions. 2. Draw lettering (for monogramming) or design (for embroidering) on the right side of the material. 3. Stretch work between embroidery hoops as firmly as possible. 4. Place the work under the needle and lower presser bar. r. 5. Pull lower thread up through the work at starting position by turning balance wheel and make a few holding stitches. 6. Hold the hoop with thumb and forefingers of both hands while pressing the material with middle and third fingers and supporting the outside of hoop with smaller finger. ... ace MONOGRAMMING 1. Sew, moving hoop slowly along the lettering at an even rate of speed. 2. Secure with a few straight stitches. (NOTE: These instructions also apply to embroidering) --- ---..• : I EMBROIDERING 1. Stitch outline of design by moving embroidery hoop accordingly. 2. Fill in design stitch from outline of design to inside and from inside to edge of outline alternately until design is completely filled in. Keep stitching close together. NOTE: A long stitch is made by moving embroidery hoop rapidly and a short stitch is made by moving it slowly. - 28 -