Brother International XR-46C Users Manual - English - Page 76
Reprisage
View all Brother International XR-46C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
USING ATTACHMENTS AND APPLICATIONS UTILISATION DES ACCESSOIRES ET LEURS APPLICATIONS USO DE ACCESORIOS Y APLICACIONES A Darning Pattern Stitch Length Any Foot Zigzag Presser Foot 1. Remove the power supply plug from the outlet. And place the darning plate on the needle plate as shown in fig. A. Connect the power supply plug into a wall outlet. 2. Set the Pattern Selection Dial to Straight Stitch. 3. Place the portion to be darned under the presser foot together with a fabric for reinforcement. 4. Lower the presser foot. 5. Begin sewing alternating between gently drawing the work away from you and pulling it toward you. 6. Repeat this motion until the portion to be darned is filled with B parallel lines of stitching.(See fig. B.) Reprisage Zurcido Modèle de point Longueur de point N'importe quelle longueur Pied-debiche Pied pour zigzag 1. Débrancher le cordon d'alimentation de la prise. Placer la plaque à repriser sur la plaque d'aiguille, comme indiqué sur la fig. A. Brancher la fiche d'alimentation à une prise secteur. 2. Mettre le sélecteur de modèle de point sur le point droit. 3. Placer la partie à repriser sous le pied-de-biche avec une toile de renfort. 4. Abaisser le pied-de-biche. 5. Commencer à coudre en donnant au tissu un mouvement de va-et-vient (en le poussant et en le tirant doucement). 6. Répéter l'opération jusqu'à ce que la partie à repriser soit remplie de lignes de points parallèles. (Voir fig. B.) Modelo de puntada Largo de puntada Cualquiera para zigzag Prensatelas Prénsatelas 1. Desenchufe la clavija de alimentación de la toma de corriente, y ponga la placa de zurcir en la placa de la aguja como se muestra en la fig. A. Conecte el enchufe de alimentación a una toma de corriente. 2. Coloque el selector de puntadas en la puntada recta. 3. Ponga la parte de tejido que se debe zurcir debajo del prensatelas, con un tejido de refuerzo. 4. Baje el prensatelas. 5. Empiece a coser empujando y tirando alternativamente del tejido. Cuando la placa de zurcir está puesta en la máquina, los sobre el tejido. 6. Repita esta operación hasta que el zurcido se haya completado, creando unas cuantas líneas de puntadas paralelas. (Véase fig. B.) 65