Browning A-Bolt Shotgun Owners Manual - Page 26
The trigger pull adjustment screw is located just behind - stock
View all Browning A-Bolt Shotgun manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Figure 12 Figure 13 Carefully loosen the screws that secure the trigger guard. Carefully lift the trigger guard from the stock. The A-Bolt Shotgun's trigger is pre-set at the factory. The trigger pull weight can be adjusted within a range of approximately 3 to 6.5 pounds. Though additional trigger adjustments should be unnecessary, the trigger pull weight can be tuned to your specifications by performing the following procedure: 1 Press the magazine release in front of the trigger guard and allow the hinged floorplate-magazine unit to swing downward. 2 Remove the magazine from the firearm. 3 Open the bolt and verify the firearm is unloaded. 4 Remove the two screws that retain the trigger guard with a standard screwdriver (Figure 12). 5 Lift the trigger guard out of the stock (Figure 13). 6 The trigger pull adjustment screw is located just behind the trigger (Figure 14). Use a small standard screwdriver to perform the adjustment. • To increase the weight of the trigger pull, turn the adjustment screw in a counterclockwise direction. • To decrease the weight of the trigger pull, turn the adjustment screw in a clockwise direction. 24