Campbell Scientific CM106B CM106B Tripod - Page 18
Installing the Optional Guy Kit, CM106B Tripod, Guy collar
View all Campbell Scientific CM106B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
CM106B Tripod 6.1.3 Installing the Optional Guy Kit Part 29813, CM106B Guy Kit, can be ordered separately for areas that experience high wind speeds (Section 5, Specifications). Install the guy brackets to the mast as shown in FIGURE 6-5. Attach the three guy wires to the guy collar and slide the collar over the mast so that the collar butts against the brackets. Guy Collar Guy Wire Guy Bracket FIGURE 6-5. Guy collar On the end of each guy line is a case and hardware to attach to the turnbuckles. Unscrew the turnbuckles so that only 1/2 in. of thread extends beyond the inside of the turnbuckle body. Attach the case and turnbuckle to the tripod leg as shown in FIGURE 6-6. Loosen the two clamp nuts, and remove the slack in the guy line by feeding the load end of the guy wire through the case while pulling up on the free end. After the slack has been removed from the guy lines, tighten the clamp nuts, and then tighten the turnbuckles to the desired tension. 10