Canon 2223B002 REALiS Manual - Page 27
Preparing the Remote Control
![]() |
UPC - 013803087239
View all Canon 2223B002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Preparing the Remote Control Installing Remote Control Batteries 1 2 Open the battery com- Insert batteries. 3 partment lid. Insert new two AAA-size Slide the lid with it batteries in the compart- pressed down. ment with the + and - poles positioned cor- rectly. Replace the compartment lid. BEFORE USE z You can check the batteries of the remote control by pressing the [LIGHT] button. If all buttons on the remote control do not light when the [LIGHT] button is pressed, or buttons are inoperative when you attempt to operate the projector, replace with new batteries. z It is recommended to check the batteries before a presentation. Remote Control Operating Range Point the remote control to the infrared remote receiver on the front or rear of the projector whenever pressing any button. z Use the remote control within a distance of approximately 5 m (16.4') from the projector. z Use the remote control within an angle of 30° in any direction from directly in front of the infrared remote receiver. 30° 5 m (16.4') 30° 5 m (16.4') 30° 30° The remote control may be inoperative if: z There is an obstacle between the remote control and main unit. z The infrared remote receiver on the main unit is exposed to direct sunlight or strong light of lighting equipment. z The remote control uses infrared light. z When you use two projectors at the same time, you can change the channel settings to pre- vent the two remote controls from interfering with each other (P111). 27
![](/manual_guide/products/canon-2224b002-realis-manual-5dd60c9/27.png)