Canon C50iR User Manual - Page 120

Schedule Setting Tool Motion detection status and screen display Tip The area in which the VB-C50i/VB-C50iR is performing motion detection appears in a blue frame in the Viewer. The selected sensitivity at which the VB-C50i/ VB-C50iR is performing motion detection appears as a yellow or red rectangle in the motion detection frame. Yellow rectangle: Where the device has detected motion, but because Area Ratio and Duration have not reached their setting value, the device does not detect motion. Red rectangle: Where the device has detected motion, and Area Ratio and Duration has reached its setting value, the device detects motion. Where there is a variation in the image, the value set in Area Ratio is displayed as a vertical line in the indicator. The indicator displays in the following 2 colors. Green: The area of the motion detected by the device has not reached Area Ratio. Yellow: The area of the motion detected by the device has reached Area Ratio. When "Sensitivity", "Area Ratio" and "Duration" are satisfied, and the VB-C50i/VB-C50iR detects motion and performs specified actions such as picture recording, a red peak block appears. You can set the degree of motion for which the peak block is displayed while monitoring the actual image. (Area ratio for motion) Set value or above Below set value Duration Indicator color Green Duration Yellow Peak displayed (red) Green Time Detection results Not detected Detected Not detected When the situation where the motion has exceeded the area ratio continues for longer than the time set in "Duration", the VB-C50i/VB-C50iR detects motion and a peak block appears. When there is motion detection and the peak block has appeared, only Duration will maintain motion detection status, even if less than the specified Area Ratio. 4-50