Canon CINE-SERVO 50-1000mm T5.0-8.9 EF User Manual - Page 52

5 OPERATION 5-1-5. Shuttle-Shot Function This function allows you to switch between the current zoom position and the preset zoom position at the maximum speed. The "Shtl" switch is held down. The "Shtl" switch is released. Current zoom position Max speed Shuttle memory position Max speed Previous zoom position Before using shuttle-shot function, the shuttle function must be assigned to the VTR, RET, or AUX switch of the drive unit, or the AUX1 or AUX2 switch on the zoom demand. This manual describes the "Shtl" function assigned to the VTR switch. For details, refer to "5-6 SWITCH OPERATIONS". Setting the shuttle memory position Zoom Rocker Seesaw "Shtl" Switch MEMO Switch Zoom to the position that you want to store. Keeping this position, press the "Shtl" switch while holding down the MEMO switch. The "position" you stored here is different from the one you set in "Framing Preset" mentioned later. The stored position set here is retained even after the power is turned off. The operation with the "Shtl" switch is given the priority over that with the zoom rocker seesaw. The operation with the zoom rocker seesaw is disabled while the "Shtl" switch is pressed. 5-1-6. Speed Preset This function allows you to call the preset zoom speed any time you zoom. Assign the "Sped" function to the VTR, RET, or AUX switch of the drive unit, or AUX1 or AUX2 switch on the zoom demand. This manual describes the "Sped" function assigned to the VTR switch. 1.ɹStoring the zoom speed and direction Zoom Rocker Seesaw "Sped" Switch Operate the zoom rocker seesaw to determine the zoom speed and direction (toward telephoto angle or widest angle) which you want to store, and press the MEMO switch while holding this position. The stored zoom speed is applied to the "Framing Preset". MEMO Switch E12