Canon CanoScan N650U User Guide - Page 27

Calibration, Reset Default Settings, Close Plug-in After Scan - installer

Get Canon CanoScan N650U PDF manuals and user guides View all Canon CanoScan N650U manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

STEP 1 Calibration Adjusts the white balance to the correct value so that all the colors are scanned correctly. Calibration takes approximately 1 minute. If the color balance of a scanned image is off-balance, select this option to calibrate the scanner input. Reset Default Settings Returns the preference settings and all other settings to the factory default settings. The tables list the major default settings. Scan Mode Magnification Unit Basic Resolution Control Panel Position Image Unsharp Mask Descreen Color (Photos) 100% Pixels 72 dpi Center Standard Off Off Close Plug-in After Scan This setting determines whether or not Plug-in Module CS-U closes automatically after completion of the scanning job. After you install Plug-in Module CS-U, this setting is set to on (Plug-in Module CS-U closes at completion of scanning). To turn this feature off, open the [Preferences] menu and select [Close Plug-in After Scan]. This feature is switched off when you don't see it marked with a check mark. To switch the feature on, click it again to show the check mark. 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
27
S T E P
1
Calibration
Adjusts the white balance to the correct value so that all the colors are scanned
correctly. Calibration takes approximately 1 minute. If the color balance of a
scanned image is off-balance, select this option to calibrate the scanner input.
Reset Default Settings
Returns the preference settings and all other settings to the factory default
settings. The tables list the major default settings.
Scan Mode
Color (Photos)
Magnification
100%
Unit
Pixels
Basic Resolution
72 dpi
Control Panel Position
Center
Image
Standard
Unsharp Mask
Off
Descreen
Off
Close Plug-in After Scan
This setting determines whether or not Plug-in Module CS-U closes automatically
after completion of the scanning job. After you install Plug-in Module CS-U, this
setting is set to on (Plug-in Module CS-U closes at completion of scanning). To turn
this feature off, open the [Preferences] menu and select [Close Plug-in After Scan].
This feature is switched off when you don’t see it marked with a check mark. To
switch the feature on, click it again to show the check mark.