Canon LV-7210 lv7215_7210_5210_manual.pdf - Page 16

Installation Positioning the Projector This projector is designed to project on a flat projection surface and can be focused from 3.3'(1.0m) - 25.3'(7.7m). Refer to the figure and the table below for the screen size and the distance between the projector and the screen. A:B = 9:1 25.3' (7.7m) 16.1' (4.9m) 12.5' (3.8m) 8.2' (2.5m) 3.3' (1.0m) 100" 40" 62" 150" 95" 190" 122" (Inch Diagonal) 300" Max. Zoom 190" Min. Zoom A (Center) B Screen Size (W x H) mm 4 : 3 aspect ratio Zoom (min) Zoom (max) 40" 813 x 610 5.2' (1.6m) 3.3' (1.0m) 100" 2032 x 1524 13.1' (4.0m) 8.2' (2.5m) 150" 3048 x 2286 19.7' (6.0m) 12.5' (3.8m) NOTE G The brightness in a room has a great influence on picture quality. It is recommended to limit ambient lighting in order to provide the best image. G The values shown are approximate and may vary from the actual size. 190" 3861 x 2896 25.3' (7.7m) 16.1' (4.9m) 300" 6096 x 4572 ----- 25.3' (7.7m) Adjustable Feet Projection angle can be adjusted up to 11.9 degrees with the adjustable feet. 1 Lift the front of the projector and pull the feet lock latches on both sides of the projector. 2 Release the feet lock latches to lock the adjustable feet and rotate the adjustable feet to adjust the position and tilt. 3 To retract the adjustable feet, lift the front of the projector and pull and undo the feet lock latches. Keystone distortion of the projected image can be adjusted by menu operation. (p20, 38) CAUTION Tilt the projector within the adjustable range in order to preserve the life of the lamp. The proper angle should be set. See page 5. 16 Adjustable Feet Feet Lock Latches