Canon LV-7210 lv7215_7210_5210_manual.pdf - Page 40

Setting Lamp mode This function allows you to change brightness of the screen. ···· normal brightness ···· the controlled brightness according with input signal ···· lowers brightness, reduces the lamp power consumption, and extends the lamp life. Pointer You can emphasize a part of the projected image with this function. Choose either Spotlight or Pointer with the Point Up/Down button and press the SET button. Then select one of three different sizes (Large, Middle, and Small) of Spotlight or a pointer of three different patterns (Arrow, Finger, and Dot) of Pointer. (See page 13 for operation.) Remote control This projector provides eight different remote control codes (Code 1Code 8); the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). This switching function prevents remote control unit interference when operating several projectors or video equipment at the same time. For example operating the projector in "Code 7", both the projector and the remote control unit must be switched to "Code 7". To change the code for the projector; Select a remote control code in this Setting Menu. To change the code for the remote control; While holding down the MENU button, press the IMAGE button number of times corresponding to the remote control code for the projector. (See page 14 for details.) Key lock This function locks operation of the top control and remote control unit. It is useful to prevent operation by a third person. ···· not locked. ···· locks operation of the top control. To unlock, use the remote control unit. ···· locks operation of the remote control unit. To unlock, use the top control. If the top control accidentally becomes locked and you do not have the remote control nearby, disconnect the AC power cord to turn off the power, and then while pressing the SET button, reinsert the AC power cord. This will cancel the top control lock. Lamp counter reset This function is used to reset the lamp replace counter. When replacing the projection lamp, reset the lamp replace counter by using this function. See page 44 for operation. Pointer Remote control Select Spotlight or Pointer with the Point Up/Down button and press the SET button. Then select size or pattern with the Point Left/Right button. When pressing the SET button at Remote control, the remote control code menu appears. Key lock Select Key lock and this box appears. Choose one of these with the Point Up/Down button and select [Yes] to activate it. Factory default Factory default This function returns all setting values except for the lamp counter to the factory default settings. 40 Select Factory default and this box appears. Select [Yes] , and the next box appears. Select [Yes] to activate it.