Canon LV-8300 Projector Monitoring Software Ver.1.0.0 User's Manual - Page 3

Introduction - network

Get Canon LV-8300 PDF manuals and user guides View all Canon LV-8300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

CHAPTER 1 • Introduction CCCCCCCCCC Introduction 1111 Introduction Process Prepare for introduction of this software as shown below. 1 Preparing an administrative computer ▼ Prepare an administrative computer that is connected to a network. Projectors connected to the local area network can be managed. If the network is managed under a subnet, network settings on the administrative computer must be configured to gain access to the target projector. Contact the system administrator for details. 2 Preparing the Projector ▼ Connect a projector for management to the network, and configure its network settings. In addition, you must configure the SNMP settings of the projector when using SNMP protocol. For procedures on configuring the projector, see the instruction manual that came with the projector. 3 Installing the Software ▼ Install this software on to the administrative computer. (see p. 4, 1.3 Installing the Software) 4 Configuring Network Settings of the Software Configure the protocol settings and the polling interval settings for discovery. (see p. 5, 1.4 Configuring the Network Settings of the Software) 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
3
CHAPTER 1 • Introduction
Introduction
C±²³T´µ ¶
Introduction ³rocess
¶1¶
Prepare for introduction of this software as shown below.
¶ ³reparing an administrative
computer
Prepare an administrative computer that is
connected to a network. Projectors connected to
the local area network can be managed.
If the network is managed under a subnet,
network settings on the administrative computer
must be configured to gain access to the target
projector. Contact the system administrator for
details.
▼
2 ³reparing the ³rojector
Connect a projector for management to the
network, and configure its network settings. In
addition, you must configure the SNMP settings
of the projector when using SNMP protocol. For
procedures on configuring the projector, see the
instruction manual that came with the projector.
▼
3 Installing the Software
Install this software on to the administrative
computer.
(see p. 4,
1.3 Installing the Software
)
▼
4 Configuring Network
Settings of the Software
Configure the protocol settings and the polling
interval settings for discovery.
(see p. 5,
1.4 Configuring the Network Settings
of the Software
)