Canon LV-8300 Projector Monitoring Software Ver.1.0.0 User's Manual - Page 9

To delete an unnecessary IP address, select an item from the discovery

Get Canon LV-8300 PDF manuals and user guides View all Canon LV-8300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

CHAPTER 1 • Introduction 44 Complete the dialog with necessary information and click the [OK] button. Category IP address Port number Timeout Description Enter an IP address of the projector, in "XXX.XXX.XXX.XXX" form. Enter a port number to be used, in one-byte numbers. Default value is set to "7142." Enter a number of seconds to time out, from 1 to 9. Note -- An error message will appear and settings will not be registered if a value of an entry is invalid or insufficient. Correct it as required. -- Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before clicking the [OK] button. -- To change an IP address, select an item from the discovery range list and click the [Edit] button to reconfigure the settings. -- To delete an unnecessary IP address, select an item from the discovery range list and click [Delete]. -- Projectors may doubly display when the IP address of a projector is changed. In this case, delete the projector with an old IP address. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
9
CHAPTER 1 • Introduction
Complete the dialog with necessary information and click the [OK] button.
4
Category
Description
IP address
Enter an IP address of the projector, in "XXX.XXX.XXX.XXX" form.
Port number
Enter a port number to be used, in one-byte numbers. Default
value is set to "7142."
Timeout
Enter a number of seconds to time out, from 1 to 9.
Note
An error message will appear and settings will not be registered if a value
-
of an entry is invalid or insufficient. Correct it as required.
Entries will be cancelled if [X] (Close) or [Cancel] button is clicked before
-
clicking the [OK] button.
To change an IP address, select an item from the discovery range list and
-
click the [Edit] button to reconfigure the settings.
To delete an unnecessary IP address, select an item from the discovery
-
range list and click [Delete].
Projectors may doubly display when the IP address of a projector is
-
changed. In this case, delete the projector with an old IP address.