Canon PIXMA MP495 Network Setup Troubleshooting - Page 8

ENGLISH Problems during Network Setup Glossary • IP address A numerical identification assigned to each computer or network device connected to a network. • IP address filtering A function to allow or block traffic from network devices with specified IP addresses. • DHCP function A function to automatically assign required information (IP address, etc.) to computers, printers or other devices connected to the network. • Privacy separator feature A function to prevent communication between multiple wireless devices (such as computers and printers) connected to an access point. WPS "E > 2 > 0" is Displayed Action The error appears when attempting to configure LAN settings of the machine from the Operation Panel while they are being configured in another way. Configure the settings after completing the settings. "E > 2 > 3" is Displayed Action The message appears when multiple access points are detected. Wait for a while, then configure the settings again. "E > 2 > 4" is Displayed Check The message appears when an error occurs. Check the access point settings, then configure WPS settings again. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" in the printed manual: Getting Started. • When using an access point that does not support WPS, configure the settings by referring to "6 Set Up a Wireless Connection" in the printed manual: Getting Started.