Canon PowerShot G11 Professional Products 2010 Brochure - Page 25

EOS-1D Mark IV Custom Function Chart Custom Function C.Fn I: Exposure Function Description 1 Exposure level increments 2 ISO speed setting increments 3 Set ISO speed range 4 Bracketing Auto Cancel 5 Bracketing sequence 6 Number of bracketing shots 7 Spot metering link to AF point 8 Safety Shift 9 Select usable shooting modes Select usable 10 metering modes No. Setting 0 1/3-stop set 1/3-stop compensation 1 1-stop set 1/3-stop compensation 2 1/2-stop set 1/2-stop compensation 0 ISO set in 1/3-stop increments 1 ISO set in 1-stop increments Disable (camera ISO range 100~3200) Enable (apply user-registered available ISO range) - Highest ISO Speed 100 - 12800, H1,H2,H3 [TD] (1-stop increments) Register Lowest ISO Speed L, 100 - 12800 Apply 0 On (AEB cancels if camera turned off, etc.) 1 Off (AEB remains in effect unless flash turned on) 00 -+ 1- 0+ 2+ 0- 0 3 shots 1 2 shots 2 5 shots 3 7 shots 0 Disable (spot metering always at center) 1 Enable (spot metering at manually selected AF pt.) 0 Disable 1 Enable (Tv/Av modes) 2 Enable (ISO speed shifts, in P, Tv, Av modes) Disable (all exposure modes available) Enable (only modes registered are selectable) - M P Register Tv BULB Av Apply Disable (all metering patterns available) Enable (only metering modes registered are selectable) - Register Apply 11 Exposure mode in manual expo. 12 Set shutter speed range 13 Set aperture value range Apply shooting/ 14 Metering mode 15 Flash sync. speed in Av mode 16 AE Microadjustment 17 FE Microadjustment C.Fn II: Image/Flash exp/Display Long exp. noise 1 reduction 2 High ISO speed noise reduction 3 Highlight tone priority 4 Auto Lighting Optimizer 0 Specified metering mode on camera's LCD panel 1 Evaluative metering only in M mode 2 Partial metering only in M mode 3 Spot metering only in M mode 4 Center-weighted average only in M mode Disable Enable (apply user-registered range) - Highest speed: 8000-15" (1-stop increments) Register Lowest speed: 30"-4000 (1-stop increments) Apply Disable (use lens's full aperture range) Enable (apply user-registered aperture range) - Min. aperture (Max. f/): 1.4-91 Register Max. aperture ((Min. f/): 1.0-64 Apply Disable (no switching to registered settings) Enable (Press " * " button to switch settings) - With AE lock button (AF on) Register With AE lock button (AF off) 0 Auto (shutter speed set based on ambient light) 1 1/300 sec - 1/60 sec. auto 2 1/300 sec. (fixed) Disable - Enable (±1 stops in 1/8-stop increments) Disable - Enable (±1 stops in 1/8-stop increments) 0 Off 1 Auto (camera decides whether to apply reduction) 2 On (noise reduction applied; 1 sec. and longer only) 0 Standard 1 Low 2 Strong 3 Disable 0 Disable 1 Enable 0 Standard 1 Low 3 Strong Custom Function 4 Function Description (Cont.) 5 E-TTL II flash metering 6 Shutter curtain sync. 7 Flash firing 8 Viewfinder info. during exp. 9 LCD panel illumination during Bulb 10 INFO button when shooting C.Fn III: Autofocus/Drive 1 USM lens electronic MF 2 AI Servo tracking sensitivity 3 AI Servo 1st/2nd image priority 4 Al Servo AF tracking method 5 Lens drive when AF impossible Lens AF stop button function 6 (select Canon Super-telephoto IS lenses only) 7 AF Microadjustment AF expansion with 8 selected pt 9 Multi-controller while meter 10 Selectable AF point 11 Switch to registered AF point 12 AF point auto selection AF point display 13 during focus 14 AF point brightness 15 AF-assist beam firing 16 Orientation linked AF point 17 Mirror lockup 18 Continuous shooting speed 19 Limit continuous shot count No. Setting 4 Disable 0 Evaluative flash metering 1 Average flash metering over all 63 metering zones 0 1st-curtain synchronization 1 2nd-curtain synchronization (EOS Speedlites only) 0 Enable 1 Disable - AF assist beam continues to operate 0 Disable 1 Enable (viewfinder info visible during bursts) 0 Off 1 On during Bulb 0 Displays shooting function 1 Displays camera settings 0 MF possible after One-shot AF completed 1 Disable after One-shot AF 2 Disable completely in AF mode - Slow: -2, -1, 0, +1, +2: Fast 0 AF priority/2nd shot onward - Tracking priority 1 AF priority/2nd shot onward - Drive speed priority 2 Release/2nd shot onward - Drive speed priority 3 Release/2nd shot onward - Tracking priority 0 Main focus point priority 1 Continuous AF track priority (ignores closer objects) 0 Focus search on 1 Focus search off 0 AF stop 1 AF start 2 AE lock 3 AF point:M Auto/Auto ctr 4 ONE SHOT AI Servo 5 IS start 6 Switch to registered AF point 7 Spot AF 0 Disable (no adjustment for front or back-focus) 1 Adjust all by same amount 2 Adjust by lens Forward: -20 ....... 0 ...... +20 Backward 0 Disable (one AF point only when manually selected) 1 Left/right AF point 2 Surrounding AF points 3 All 45 points area 0 Off 1 AF point selection 0 45 points 1 11 points 2 19 points 3 Inner 9 points 4 Outer 9 points 0 Disable 1 Switch with < > 2 Only while < > is pressed 0 direct: disable / : enable 1 direct: disable / :disable (auto AF select mode impossible to access) 2 direct: enable / : enable 0 On (red illumination on) 1 Off 2 On (lights momentarily when focus achieved) 0 Normal 1 Brighter 0 Enable (Speedlite's AF assist beam fires normally) 1 Disable 2 IR AF assist beam only 0 Same for both vertic./horiz. 1 Select different AF points 0 Disable 1 Enable (mirror lowers after each shot) 2 Enable: Down with SET (mirror remains up until SET pressed) Disable (shoots at default fps rates) Enable (applies user-registered fps rates) - Register High speed: 10 - 2 fps (per shot) Low speed: 1 - 9 fps (per shot) Apply Disable - Enable 161 Custom Function Function Description No. Setting 19 (Cont.) - C.Fn IV: Operation/Others√Operation/Others 0 1 1 Shutter curtain sync. 2 3 4 2 AF-ON/AE lock 0 button switch 1 0 1 Quick Control Dial 3 in meter 2 3 4 0 1 2 3 4 Assign SET button 4 5 6 7 5 Tv/Av setting for Manual exp. 0 1 Dial direction during 0 6 Tv/Av 1 0 7 Av setting without lens 1 8 WB + media/image size setting 0 1 0 9 Button function 1 2 10 Button function when 0 1 0 11 Start movie shooting 1 0 1 12 Focusing Screen 2 3 13 Timer length for timer _ 14 Shortened release 0 time lag 1 0 1 2 Add aspect ratio 15 information 3 4 5 6 16 Add original verification data 0 1 Register Limited shots: 99-2 Apply Metering + AF start (at both buttons) Metering + AF start/AF stop Metering start/Meter + AF start (no AF at shutter button) AE lock/Metering + AF start Metering + AF start/disable (AF-on button) Disable Enable (reverse role of AEL and AF-on buttons) Exposure comp/Aperture AF point selection (instant AF point access with rear dial) ISO speed (instant ISO access with rear dial) AF point selection + ISO speed + Normal (disabled) White balance Image size ISO Speed Picture Style Record func. + media/folder Menu display Image playback Tv= / Av= Tv= / Av= (reverse functions in M mode for top/rear dials) Normal Reverse direction Disable Enable (possible to set aperture on body w/o lens) Rear LCD panel LCD monitor (displayed when FUNC button pressed) Protect (hold: Record memo) Record memo (Protect: Disabled) Play memo (hold: Record memo) Normal (enable) Disable , , Multi-controller Default (from LV) Quick start (button) Ec-C IV Ec-A, B, C, C II, C III, D, H, I, L Ec-S Ec-N, R Disable (use camera's built-in settings) Enable (apply user-registered changes) 6 sec. timer: 0-6-59 sec., 1-60 min. Register 16 sec. timer: 0-16-59 sec., 1-60 min. Time after release: 0-2-59 sec., 1-60 min. Apply Disable (standard 55ms "time lag") Enable (as low as 40ms, depending upon lens aperture) Off Aspect ratio 6:6 Aspect ratio 3:4 Aspect ratio 4:5 Aspect ratio 6:7 Aspect ratio 10:12 Aspect ratio 5:7 Off On (used by optional Original Data Security Kit) EOS 5D Mark II Custom Function Chart Custom Function Function Description C.Fn I: Exposure 1 Exposure level increments 2 ISO speed setting increments 3 ISO expansion 4 Bracketing auto cancel 5 Bracketing sequence 6 Safety shift 7 Flash sync. speed in Av mode C.Fn II: Image 1 Long exposure noise reduction 2 High ISO speed noise reduction 3 Highlight Tone Priority 4 Auto Lighting Optimizer C.Fn III: Autofocus/Drive 1 Lens drive when AF impossible 2 Lens AF stop button function 3 AF point selection method 4 Superimposed display 5 AF-assist beam firing 6 Mirror lockup 7 AF point area expansion 8 AF Microadjustment C.Fn IV: Operation/Others 1 Shutter button/AF-ON button 2 AF-ON/AE lock button switch 3 Assign SET button 4 Dial direction during Tv/Av 5 Focusing screen 6 Add original decision data No. Setting 0 1/3-stop 1 1/2-stop 0 1/3-stop 1 1-stop 0 Off 1 On 0 On 1 Off 0 0, -, + 1 -, 0, + 0 Disable 1 Enable (Tv/Av) 0 Auto 1 1/200-1/60 sec. (auto) 2 1/200 sec. (fixed) 0 Off 1 Auto 2 On 0 Standard 1 Weak 2 Strong 3 Disable 0 Disable 1 Enable 0 Standard 1 Weak 2 Strong 3 Disable 0 Focus search on 1 Focus search off 0 AF stop 1 AF start 2 AE lock 3 AF point: M Auto/Auto ctr 4 ONE SHOT AI SERVO 5 IS start 0 Normal 1 Multi-controller direct 2 Quick Control Dial direct 0 On 1 Off 0 Enable 1 Disable 0 Disable 1 Enable 0 Disable 1 Enable 0 Disable 1 Adjust all by same amount 2 Adjust by lens 0 Metering + AF start 1 Metering + AF start/AF stop 2 Metering start/Meter + AF start 3 AE lock/Metering + AF start 4 Metering + AF start/disable 0 Disable 1 Enable 0 Normal (disabled) 1 Change quality 2 Change Picture Style 3 Menu display 4 Image replay 5 Quick control screen 6 Record movie (Live View) 0 Normal 1 Reverse direction 0 Eg-A 1 Eg-D 2 Eg-S 0 Off 1 On 162