Canon VB-M720F Network Video Recording Software RM Series Administrator s Manu - Page 55
Edit Camera Information
View all Canon VB-M720F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Add a Camera 6 Repeat steps 4 and 5. (3) [Tags] Displays the tags assigned to the camera. 7 When you finish adding cameras click [Cancel]. (4) [Edit] Add a new tag to the list in (3). 3 (5) [Remove] Storage Server Settings Note • You can only search for cameras on the same subnet as the Storage Server. For details on how to add cameras on a different subnet, see "Add Cameras One at a Time" (p. 53). Remove tags selected in (4). (6) [OK] and [Cancel] Close the dialog box. (7) [Apply] • The names of the cameras (stored on the camera) are displayed in the list in the [Camera Search Results] dialog box. However, the VB-C300 camera name is not displayed. Apply the settings in the dialog box. Note • Cameras that have already been added are also found. However, a check box is not displayed next to the camera. • If you cannot find the camera you are searching for, see "Add Cameras One at a Time" (p. 53) and add the camera. The camera name specified in the text box is only used by this software product. The camera name stored on the camera is not changed. [Advanced] tab • Host names or IPv4 addresses are displayed in the [Host Name] column of the [Camera Search Results] dialog box. (IPv6 addresses are not supported.) (1) (2) (3) Edit Camera Information (4) (5) You can edit the camera registration information, such as (6) the camera name or the thumbnail image displayed in the Viewer. 1 Select a camera in the list and click [Edit] in the [Settings] dialog box to display the camera properties. 2 Configure the displayed settings. [General] tab (1) (2) (3) (4) (5) (6) (7) (1) Camera name box Enter a camera name. (2) [Update] Update the thumbnail image in the camera selection panel. (7) (8) (1) [Host Name] Change the host name or IP address of the camera. (2) [Port] Change the port number used for communicating with the camera. Typically, leave [80] unchanged. (3) [User Name] Change the user name of the camera. (4) [Password] Change the password for the user entered in (3). (5) [Disable Camera] Disables the camera temporarily. To enable the camera, click [Enable Camera]. (6) [Storage Server Group] Displays the Storage Server Group where the camera is registered. (7) [OK] and [Cancel] Close the dialog box. (8) [Apply] Apply the settings in the dialog box. 55