Canon imageCLASS MF4880dw Wireless Guide - Page 5

Setting the Wireless LAN  • You should press the WPS button within 2 minutes after you select in step . • Press and hold* the button until the lamp lights or blinks. * The time that you should hold the button may vary depending on the router you are using. Move to the machine  When an error message appears: Press [OK] to close the screen, check whether or not the network key is correct, and then retry the settings. If the access point cannot be detected even after retrying, see the following. "When an Error Message Appears" (P.14) When checking the network connection: You can check if the machine is properly connected to the network using a computer that is connected to a network. "Checking that the Wireless LAN Setting is Completed" (P.9) When setting an IP address manually: "Setting by Manually Entering SSID" in the e-Manual • After the screen is displayed, wait until the Wi-Fi indicator stops blinking and turns on. Wait approximately 2 minutes after the connection is completed. The IP address is set during this time period. Proceed to P.9 1 Prepare for Wireless LAN Connection 2 Setting the Wireless LAN 3 Installing the Software 4 Troubleshooting 5