Canon imageCLASS MF4880dw Wireless Guide - Page 8
Proceed to P.9
 |
View all Canon imageCLASS MF4880dw manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setting the Wireless LAN • After the screen is displayed, wait until the Wi-Fi indicator stops blinking and turns on. Wait approximately 2 minutes after the connection is completed. The IP address is set during this time period. Proceed to P.9 When an error message appears: Press [OK] to close the screen, check whether the network key is correct or not, and then retry the settings from step . If the access point cannot be detected even after retrying, see the following. "When an Error Message Appears" (P.14) When setting IP address manually: "Setting by Manually Entering SSID" in the e-Manual 8
-
1 -
2
-
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
8
Setting the Wireless LAN
»
•
After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking
and turns on.
Wait approximately 2 minutes
after the connection is completed.
The IP address is set during this time period.
When an error message appears:
Press [OK] to close the screen, check whether the
network key is correct or not, and then retry the
settings from step
´
.
If the access point cannot be detected even after
retrying, see the following.
“When an Error Message Appears” (P.14)
When setting IP address manually:
“Setting by Manually Entering SSID” in the
e-Manual
Proceed to P.9