Canon imageFORMULA CR-135i imageFORMULA CR-135i / CR-190i Installation Guide - Page 10

Preparation Before Use This chapter describes how to prepare the scanner to scan documents. Setting Up the Scanner Perform the following steps to set up the CR-135i/CR-190i. Refer to the section for each step for details about that step. 1 Check your operating environment. (See "Checking Your Operating Environment" on p. 11.) 2 Install the software. (See "Installing the Scanning Utility" on p. 11.) Install the Scanning Utility provided with the CR-135i/CR-190i. IMPORTANT • To have the device drivers installed automatically when the computer recognizes the CR-135i/CR-190i, the software needs to be installed before the CR-135i/CR-190i is connected to the computer. • If you connect the computer and turn ON the CR-135i/CR-190i before installing the software, the following wizard screen appears. If this happens, click [Cancel], turn OFF the CR-135i/CR-190i, and then install the software. The following wizard screen is an example in Windows Vista. When a similar wizard screen appears in Windows XP/7, click [Cancel]. 3 Connect the scanner to a computer. (See "Connecting the Scanner to a Computer" on p. 12.) 4 Turn ON the power. (See "Turning ON the Power" on p. 13.) Wizard Screen (Windows Vista) 5 Automatically installing the device driver. (See p. 14.) The device driver is installed automatically when Windows recognizes the CR-135i/CR-190i. 10