Canon imagePROGRAF W8400D Large Format Printer Move Procedure
Canon imagePROGRAF W8400D Manual
View all Canon imagePROGRAF W8400D manuals
Add to My Manuals
Save this manual to your list of manuals |
Canon imagePROGRAF W8400D manual content summary:
- Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 1
moving it, please contact the dealer where you purchased the printer or the nearest service center. • Before you move the printer, always execute the Move Printer menu function and follow the directions given by the messages on the display. The printer may be damaged if you attempt to move it after - Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 2
to display MAIN MENU. 3 Press [ ] or [ ] to select Maintenance, then press [ ]. 4 Press [ ] or [ ] to select Move Printer then press [ ]. 5 Press [ ] or [ ] to select Yes, then press OK. Open RightCover is displayed. 6 Open the back right cover. Remove Ink Tank is displayed on the operation panel. - Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 3
tank covers, then close the right cover. Please Wait.. appears followed by Ink Draining..while the ink is sucked from inside the tubes. This process requires about 4 minutes to complete. The printer switches off automatically once the process is complete. 9 Disconnect the power cord, earth wire and - Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 4
10 Open the top cover, and then open the paper tray. Do not touch any areas other than as indicated. Doing so may damage the printer. 11Rewind the roll media back onto the roll and remove the roll holder and the four overwind prevention stays, and then remove the paper tray. - Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 5
13 Clamp the belt with the belt stopper then use the hex screws to fasten the belt stopper. Attach the belt stopper that you removed and stored during the initial installation. 14 Close the top cover. 15 Remove the accessory pocket. - Canon imagePROGRAF W8400D | Large Format Printer Move Procedure - Page 6
order of tape removal during setup. 17 To remove the stacker, apply the attachment procedure in reverse. 18 Apply the printer mounting procedure in reverse to unmount the printer. 19 Apply the stand assembly procedure in reverse to disassemble and pack the stand. 20 Reattach the tapes and shipping
Moving the Printer
Follow this procedure before moving the printer to protect the internal parts
during moving or shipping.
•
If you cannot avoid tilting or standing the printer on end when you are
moving it, please contact the dealer where you purchased the printer
or the nearest service center.
•
Before you move the printer, always execute the Move Printer menu
function and follow the directions given by the messages on the
display. The printer may be damaged if you attempt to move it after
disconnecting the power cord before switching off the printer. If you
accidentally disconnect the power cord before switching the printer off,
reattach the power cord, reinstall the ink tanks, then start the
procedure again from Step 1.
•
You cannot execute Move Printer once the MTCart Full Soon or
Replace MT-Cart appears. Replace the maintenance cartridge before
executing Move Printer.
•
Never tilt the printer while you are moving it. This could spill ink from
the maintenance cartridge and cause ink stains in the surrounding
area.
1
If the printer power is off, press the
Power
button to switch the printer
on.
After a few moments, Online appears in the display.