Canon imagePROGRAF iPF840 User Guide - Page 594
Other Maintenance, Preparing to Transfer the Printer
View all Canon imagePROGRAF iPF840 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 594 highlights
Preparing to Transfer the Printer Other Maintenance iPF840 Preparing to Transfer the Printer ...594 Reinstalling the Printer ...599 Updating the Firmware ...602 Preparing to Transfer the Printer To protect the internal parts in transit, always follow these steps before transferring the printer to a new location. Refer to the Setup Guide for details on packing the printer and installing it after transfer. • Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damage Important the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit. • Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer Note (that is, when you execute the printer menu item to prepare for transfer). • Ink must be drawn into the Maintenance Cartridge before Level 2 or Level 3 printer transfer, as described in the following table. Prepare the Maintenance Cartridge in advance. • Always follow the instructions of the service representative when transferring the printer under Level 3 conditions. Transport and Storage Level In Low Temperature Environments Permitted Angle of Inclination Required Amount of Ink to Maintenance Dispose of Cartridg- es(*1) Usage Examples 1 No Lengthwise: 0-30º 0(*2) Moving Within a Room and Storage In Room Temperature Environ- ments Rotation: 0-10º Maintenance and Consumables Other Maintenance 2 Yes All directions: 0-30º Approx. 700 1 or 2 ml (20.3 fl oz) Transport By Vehicle 3 Yes Lengthwise: 0-90º Rotation: 0-30º Approx. 700 1 or 2 ml (20.3 fl oz) Move by temporarily standing vertically *1:This is the number of new Maintenance Cartridges required when you execute the Prep.MovePrinter menu. The number varies depending on the amount remaining in the Maintenance Cartridge being used. *2:If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, the Maintenance Cartridge needs to be replaced. 594 Remove paper 1 Disassemble and repackage the Wheeled Output Stacker by following the installation procedure in reverse. 2 Remove the paper. • Rolls (See "Removing the Roll from the Printer.") ➔P.352 User's Guide