Casio KL 750B Owners Manual - Page 17
Troubleshooting
UPC - 079767156787
View all Casio KL 750B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
To initialize the Label Printer 1. Turn power off. 2. While holding down the PRINT and ESC keys, press ON to turn power on. 3. Keeping PRINT and ESC held down, release the ON key only. • This prompt confirms whether or not you want to initialize the Label Printer. INT? 4. Press SET to initialize the Label Printer or ESC to abort the reset operation. • The following table shows the initial settings. Item Display Memory SYMBOL EFFECT M-FEED MIRROR MEMO DENSITY WIDTH Reset Cleared Cleared , CANCEL NO OFF STR? 3 OFF Troubleshooting Problem ERR! message on the display. Possible Cause • Attempt to input two ¥ marks within the same text. • Attempt to input ¥ mark while 6mm is specified as the tape width. • Label text containing a ¥ mark was input and then tape width specification was changed to 6mm. (ERR! message appears when you try to perform a print operation.) • Text that is longer than 5.5cm when stamp printing is selected. • Attempt to print a stamp while 6mm is specified for the tape width. Action • Use only one ¥ mark. Only two lines of text can be input, so text can contain only one ¥ mark. • Do not use ¥ marks. 6mm tape can have only one line of text, so text cannot contain any ¥ marks. • Delete the ¥ mark to print on 6mm tape or switch back to a wider tape. • Shorten the text to be printed and try again. • Change the tape width setting to OFF and try printing the stamp again. FUL! message on the display. • Both text memory areas (AREA 1 and AREA 2) already contain text. • Delete text from one of the text memory areas and then store the new text. BATT message • Battery power is too on the display. low. • Replace batteries. ERR! message on the display. • Memory data has become corrupted for some reason. • Initialize the Label Printer. E-16