Casio KL 750B Owners Manual - Page 7
Tape Width Specification - label printer
UPC - 079767156787
View all Casio KL 750B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Important! 4. Use a pencil or some other thin object to take • Never try to push the tape back into the cassette. Once tape is out of the up slack in the ink ribbon as shown in the illus- cassette, there is no way to wind it back in. Trying to do so can cause opera- tration. Note that the tape does not move at this tional problems with the Label Printer. time. To load a tape cartridge • If the ink ribbon is slack when you load it into the Label Printer, it can break or cause some other 1. Make sure that the Label Printer is turned off. problem. 2. Open the tape cartridge compartment cover. • If there is a cartridge already in the Label Printer, • Be sure to turn the ink ribbon take up spool only in the direction indicated by the arrow (a). (a) remove it by grasping the cartridge on both sides • Turn the spool until the other spool (b) starts turn- with your thumb and forefinger, and lift straight ing in the direction noted by the arrow. This indi- up. cates there is no slack in the ribbon. (b) 3. Remove the stopper from a new tape cartridge and check to see that the tape is ready to use. 5. Load the tape cartridge into the Label Printer, making sure that the tape and ink ribbon pass between the head and roller. 6. Close the tape cartridge compartment cover. Roller Head • Make sure that the tape is under the tape guide and that it is not bent or twisted. • Make sure that the tape does not extend too far past the tape guide. If it does, cut off the end with a pair of scissors. Tape guide 7. Turn on Label Printer power and press FUNCTION and then PRINT (FEED) two or three times to make sure that the tape comes out without any problem. • If the tape does not come out normally, turn off power and start again from step 1 above. Tape Width Specification Important! • When using 6mm tape, using certain character sizes can cause characters to run off the top or bottom of the tape. Be sure to use the following procedure to tell the Label Printer when you are using 6mm tape. To specify 6mm tape width 1. Turn power on. 2. Press FUNCTION and then 9 (6mm). 3. Press H J K or L to change the setting shown on the display between ON (6mm tape) and OFF (other tape width). 4. When the tape width setting is the way you want it, press SET to register it. • The tape width you set remains in effect until you change it or reset the Label Printer's memory. E-6