Chamberlain B550 B550 B552 B750 Owner s Manual - English - Page 25
STEP 14 Wire the Safety Reversing Sensors, OPTION A - INSTALLATION WITHOUT PRE-WIRING
View all Chamberlain B550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Installation STEP 14 Wire the Safety Reversing Sensors If your garage already has wires installed for the safety reversing sensors, proceed to page 26. OPTION A - INSTALLATION WITHOUT PRE-WIRING 1 1. Run the wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with the staples. 2. Strip 7/16 inch (11 mm) of insulation from each set of wires. Separate the wires. Twist the white wires together. Twist the white/black wires together. 3. Insert the white wires into the white terminal on the garage door opener. Insert the white/black wires into the grey terminal on the garage door opener. To insert or remove the wires from the terminal, push in the tab with a screwdriver tip. 3 HARDWARE Insulated Staple (Not Shown) 2 Staple 7/16" (11 mm) RED WHITE WHITE GREY 25