Cisco 1232AG Hardware Installation Guide - Page 77
Removing a 5-GHz Radio Module
![]() |
UPC - 882658058363
View all Cisco 1232AG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Chapter 8 5-GHz Radio Module Upgrade Removing a 5-GHz Radio Module Step 3 Remove the 5-GHz access cover using the supplied Torx L-wrench (see Figure 8-1). Figure 8-1 5-GHz Radio Access Cover 121 74632 1 Access Cover Screws 2 Access Cover Removing a 5-GHz Radio Module To remove the 5-GHz radio module, follow these steps: Step 1 Step 2 Step 3 Remove all cables and power connections from the access point. Place the access point on a flat surface so that the unit is upright with the front end facing you. Unscrew the two mounting screws using the supplied Torx L-wrench (Figure 8-2). Figure 8-2 5-GHz Radio Module 1 1 2 3 74631 1 Mounting screws 2 5-GHz radio module antenna 3 Access point Note Do not attempt to remove the mounting screws from the module; they are captured in the module housing. OL-4310-01 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 8-3
![](/manual_guide/products/cisco-1232ag-hardware-installation-guide-8ed2565/77.png)