Cisco 3845 Hardware Installation Guide - Page 266
Step 1, reset, Enter
UPC - 746320981420
View all Cisco 3845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
Related Documents Chapter 22 Connecting Cisco Intrusion Detection System Network Modules To perform online removal of a CIDS network module and insertion of a replacement, follow these steps with the router in privileged EXEC mode: Step 1 Step 2 Step 3 Step 4 Step 5 Perform a graceful halt of the CIDS network module by using the following command: Router# service-module IDS-Sensor slot/0 shutdown Trying 10.10.10.1, 2129 ... Open Wait for the following status message (it may take a minute or two): %SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown complete Unplug the network interface cable from the CIDS network module. Loosen the two captive screws holding the CIDS network module in the chassis slot. Slide the CIDS network module out of the slot. Align the replacement CIDS network module with the guides in the chassis slot, and slide it gently into the slot. Note If the router is not fully configured with network modules, make sure that blank panels fill the unoccupied chassis slots to provide proper airflow. Step 6 Step 7 Step 8 Step 9 Push the module into place until you feel its edge connector mate securely with the connector on the backplane. Reconnect the network interface cable previously removed in Step 2. Tighten the two captive screws on the faceplate. Reset the CIDS network module using the reset command. Router# service-module IDS-Sensor slot/0 reset Use reset only to recover from shutdown or failed state Warning: May lose date on the hard disc! Do you want to reset?[confirm] Step 10 Step 11 Press Enter to confirm the request. The CIDS network module resets itself. Check that the network module LEDs are on and that the power and enable LEDs on the front panel also are on. This inspection ensures that connections are secure and that the new unit is operational. Related Documents For additional information, refer to the following documents. Tip For information on obtaining documentation, see the "Obtaining Documentation" section on page viii. For information on obtaining technical assistance, see the "Obtaining Technical Assistance" section on page xi. 22-4 Cisco Network Modules Hardware Installation Guide OL-2485-20