Cisco 3845 Hardware Installation Guide - Page 64
Installing Double-Wide and Extended Double-Wide Network Modules in CiscoAccess Routers - power supply part number
UPC - 746320981420
View all Cisco 3845 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Installing Cisco Network Modules in Cisco Access Routers Chapter 2 Installing Cisco Network Modules in Cisco Access Routers Figure 2-10 Installing Single-Wide and Extended Single-Wide Network Modules in Cisco Access Routers ACT H9998 ETHERNET 0 WO SERIAL ASYNC 15 11 14 10 13 9 12 8 15 11 14 10 13 9 12 8 ASYNC 24-31 ASYNC 8-15 7 3 6 2 5 1 4 0 7 3 6 2 5 1 4 0 ASYNC 16-23 ASYNC 0-7 EN 1 2 1 Single-wide network module 2 Router chassis Step 6 Step 7 Step 8 Using the network module handle, push the module into place until you feel the edge connector seat securely into the connector on the router backplane. The network module faceplate should contact the chassis rear panel. Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module faceplate. Proceed with connecting the network module to the network and power up the router. Tip See the "Where to Go Next" section on page 2-27 for information on locating additional hardware documentation. Warning After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8 Installing Double-Wide and Extended Double-Wide Network Modules in Cisco Access Routers Network modules can be installed either before or after mounting the router, whichever is more convenient. To install a double-wide or extended double-wide network module, perform these steps: Step 1 Step 2 Step 3 Turn off electrical power to the router. Leave the power cable plugged in to channel ESD voltages to ground. Remove all network cables, including telephone cables, from the rear panel of the router. Remove the blank faceplates installed over the slot you intend to use. (See the "Installing and Removing Blank Faceplates" section on page 2-6.) Tip Save blank faceplates for future use. 2-16 Cisco Network Modules Hardware Installation Guide OL-2485-20