Cisco AS5350XM Software Configuration Guide - Page 39

Understanding Basic Hardware Architecture and Cisco IOS Software Upgrading to a New Cisco IOS Release Step 5 Reload the Cisco AS5350XM or Cisco AS5400XM universal gateway to run the new image. If you erased the old Cisco IOS image, make sure that the boot system flash oldiosname.bin command is not enabled and pointing to the old image filename; otherwise, the gateway becomes stuck trying to reload the old image over and over again. Router# reload Proceed with reload? [confirm] System Bootstrap, Version 12.0(20000106:234457) [tombnyg-rommon_1_6 106], SOFTWARE REV 1.6 Copyright (c) 1994-2000 by cisco Systems, Inc. AS5400XM platform with 524288 Kbytes of main memory Self decompressing the image OK] Self decompressing the image OK] Press RETURN to get started! Note Most sections of the boot sequence have been omitted from the example. For more information about TFTP, see the Loading and Maintaining System Images and Microcode document, available online at http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/fun_c/fcprt2/fcimages.htm Tip On system reload, if the console session freezes or displays unusual characters on the screen, you may have a console session mismatch between the Cisco IOS console line speed and the terminal server speed. This mismatch may occur because of the program settings of your console or your terminal server speed. Note Before you proceed to correct session mismatch, verify that your problem is not due to a defective cable or improper cable connection. Check your cable connection or replace the cable and reload the system again. To correct a console session mismatch, do one of the following: • Change your console line speed. • Change your terminal server speed. • If the above two solutions do not correct the console session, install the console jumper on the motherboard to set your default console port speed to 9600 bps. Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide 11