Cisco PIX 506E User Guide - Page 4
Connecting a Power Supply Module to the PIX 506/506E
UPC - 746320661315
View all Cisco PIX 506E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Connecting a Power Supply Module to the PIX 506/506E Chapter 3 PIX 506/506E Step 2 Connect the RJ-45 connector to the PIX 506/506E and connect the other end to the serial port connector on your computer (see Figure 3-7). Figure 3-5 PIX 506/506E Serial Console Cable ACT LINK ETHERNET 1 ACT LINK ETHERNET 0 USB CONSOLE DC POWER INPUT Console port (RJ-45) RJ-45 to DB-9 or DB-25 serial cable (null-modem) Computer serial port DB-9 or DB-25 38853 Step 3 Connect the inside network cable to the interface connector marked ETHERNET 0 or ETHERNET 1. Note The inside or outside network connections can be made to either interface port on the PIX 506/506E. Step 4 Connect the outside network cable to the remaining Ethernet port. Connecting a Power Supply Module to the PIX 506/506E This section describes how to connect the power supply module to the PIX 506/506E. Use this information in conjunction with the Regulatory Compliance and Safety Information document. The PIX 506/506E uses an external AC to DC power supply. Power is supplied to the PIX 506/506E by connecting the power supply to the back of the security appliance and connecting a separate AC power cord to the power supply. Cisco PIX Security Appliance Hardware Installation Guide 3-4 78-15170-02