Cisco SPA8000-G1 Administration Guide - Page 196
Dial Plan NAT Settings
View all Cisco SPA8000-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
ATA Voice Field Reference Trunk Group page (SPA8000) B Voice tab > Trunk Group page (SPA8000) > Dial Plan section Field Dial Plan Description Dial plan script for this trunk. NOTE: The trunk SUA will also apply the Trunk Dial Plan on the number before sending out INVITE to the ITSP. This Trunk Dial Plan typically is redundant since the trunk should trust the number sent by the Line SUA. By default the trunk dial plan allows any non-empty number: ([*#0-9AD][*#0-9A-D].) Voice tab > Trunk Group page (SPA8000) > NAT Settings section NAT Mapping Enable NAT Keep Alive Enable NAT Keep Alive Msg NAT Keep Alive Dest To use externally mapped IP addresses and SIP/RTP ports in SIP messages, select yes. Otherwise, select no. The default is no. To send the configured NAT keep alive message periodically, select yes. Otherwise, select no. The default is no. Enter the keep alive message that should be sent periodically to maintain the current NAT mapping. If the value is $NOTIFY, a NOTIFY message is sent. If the value is $REGISTER, a REGISTER message without contact is sent. The default is $NOTIFY. Destination that should receive NAT keep alive messages. If the value is $PROXY, the messages are sent to the current proxy server or outbound proxy server. The default is $PROXY. Cisco Small Business ATA Administration Guide 196