Cisco WAP200E-EU User Guide - Page 8
Product Overview, Front Panel, Bottom Panel, Top Panel, Product Overview - external antenna
UPC - 745883578627
View all Cisco WAP200E-EU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 3 Product Overview Chapter 3: Product Overview Front Panel The Access Point's LEDs, where information about network activity is displayed, are located on the front panel. Bottom Panel The Ethernet network port is located on the bottom panel of the Access Point. Bottom Panel Ethernet network port The Ethernet network port connects to Ethernet network devices, such as a switch or router. The Access Point is powered using Power Over Ethernet. If the switch or router doesn't support Power Over Ethernet, then a Power Over Ethernet Injector must be installed. Top Panel The antenna port is located on the top panel of the Access Point. Front Panel Power (Green) The Power LED lights up when the Access Point is powered on. Wired (Green) The Wired LED lights up when the Access Point is successfully connected to a device through the Ethernet network port. If the Wired LED is flashing, the Access Point is actively sending to or receiving data from one of the devices over the Ethernet network port. Wireless (Green) The Wireless LED lights up when the wireless module is active on the Access Point. If the Wireless LED is flashing, the Access Point is actively sending to or receiving data from a wireless device. Wireless-G Exterior Access Point with Power Over Ethernet Top Panel Antenna Port The Access Point has built-in, 1x2 MIMO 9dBi directional antennas. It also has a reverse polarity female N-type antenna port for an optional, high‑gain external antenna such as the HGA9N. One of the two internal antennas will be disabled automatically when an external antenna is connected.