Cisco WRP400 User Guide - Page 55

Configuring Your Wireless Network Wireless > Basic Wireless Settings 6 • SSID1, SSID2: The SSID is the network name shared among all devices in a wireless network. The WRP400 can support up to two wireless networks. By default, one wireless network is enabled, and you can create a second wireless network. Configure the following settings for each wireless network: - Wireless Network Name (SSID): The default wireless network uses this name: "cisco" followed by the last four digits of the wireless MAC address of the WRP400. To rename the default wireless network, enter a unique Wireless Network Name, which is case-sensitive and must not exceed 32 characters. You can use any of the characters on the keyboard. To create a second wireless network, select Network Enabled for the SSID2 setting. Then enter a unique Wireless Network Name. NOTE If you are unable to configure the SSID2 settings, contact your service provider for more information. - SSID Broadcast Enabled: When wireless clients survey the local area for wireless networks, they detect the SSID broadcast by the WRP400. If you want to broadcast the SSID, keep the check box selected. If you do not want to broadcast the SSID, deselect the check box. - For Internet Access Only: On your second wireless network (SSID2), you can set up guest access, which allows access to the Internet while blocking access to your local network. For example, a guest cannot access the data stored on your local computers. To limit guests to Internet access only, keep the check box selected. To allow local network access, deselect the check box. NOTE The For Internet Access Only feature applies only to SSID2. - Network Enabled: To enable the wireless network, select the check box. To disable the wireless network, deselect the check box. Cisco WRP400 User Guide 53