Cisco WS-C2960S-48FPS-L Hardware Installation Guide - Page 101
Command-line interface CLI, Return
View all Cisco WS-C2960S-48FPS-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Appendix C Configuring the Switch with the CLI-Based Setup Program Entering the Initial Configuration Information [2] Save this configuration to nvram and exit. If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by selecting option 2. Enter your selection [2]:2 Make your selection, and press Return. After you complete the setup program, the switch can run the default configuration that you created. If you want to change this configuration or want to perform other management tasks, use one of these tools: • Command-line interface (CLI) • Network Assistant (for one or more switches) To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal emulation program or through the network by using Telnet. For configuration information, see the switch software configuration guide or the switch command reference. To use the Network Assistant, see the Getting Started with Cisco Network Assistant guide on Cisco.com. OL-7075-09 Catalyst 2960 Switch Hardware Installation Guide C-7