Cisco WS-C2960S-48FPS-L Hardware Installation Guide - Page 96
Accessing the CLI Through the Console Port, write memory
View all Cisco WS-C2960S-48FPS-L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Accessing the CLI Appendix C Configuring the Switch with the CLI-Based Setup Program After you have entered the configuration information for the switch, save it to flash memory by using the write memory privileged EXEC command. Note While in Express Setup mode, the IP address 10.0.0.1 remains active on the switch until you enter the write memory command. You lose the Telnet connection after entering the write memory command. For more information about using the CLI, refer to the command reference for this release. Accessing the CLI Through the Console Port You can access the CLI on a configured or unconfigured switch by connecting the console port of the switch to the serial port on your PC or workstation and accessing the switch through a Telnet session. To access the switch through the console port, follow these steps: • Connecting to the Console Port, page C-3 • Starting the Terminal Emulation Software, page C-3 • Connecting to a Power Source, page C-4 • Entering the Initial Configuration Information, page C-4 See the switch getting started guide for a list of what ships with your switch. Note You need to provide the Category 5 or higher straight-through cables to connect the switch ports to other Ethernet devices. Note The auto-MDIX feature is enabled by default. For configuration information for this feature, see the switch software configuration guide or the switch command reference. Catalyst 2960 Switch Hardware Installation Guide C-2 OL-7075-09