Cisco WS-C3560-24PS-E Hardware Installation Guide - Page 113
Switch Installation 24- and 48-Port, Switches
View all Cisco WS-C3560-24PS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Appendix D Configuring the Switch with the CLI-Based Setup Program Completing the Setup Program ! end Step 10 These choices appear: [0] Go to the IOS command prompt without saving this config. [1] Return back to the setup without saving this config. [2] Save this configuration to nvram and exit. If you want to save the configuration and use it the next time the switch reboots, save it in NVRAM by selecting option 2. Enter your selection [2]:2 Make your selection, and press Return. After you complete the setup program, the switch can run the default configuration that you created. If you want to change this configuration or want to perform other management tasks, use one of these tools: • Command-line interface (CLI) • CMS from your browser • Network Assistant from your browser To use the CLI, enter commands at the Switch> prompt through the console port by using a terminal emulation program or through the network by using Telnet. For configuration information, see the switch software configuration guide or the switch command reference. To use CMS, see the CMS online help. To use Network Assistant, see the Getting Started with Cisco Network Assistant guide. For installation procedures for mounting your switch, connecting to the switch ports, or connecting to the small form-factor pluggable (SFP) modules, see Chapter 2, "Switch Installation (24- and 48-Port Switches)" and Chapter 3, "Switch Installation (8- and 12-Port Switches)." OL-6337-07 Catalyst 3560 Switch Hardware Installation Guide D-5