Cisco WS-C3560-24PS-E Hardware Installation Guide - Page 49
Removing SFP Modules from SFP Module Slots
View all Cisco WS-C3560-24PS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Chapter 2 Switch Installation (24- and 48-Port Switches) Installing and Removing SFP Modules Step 5 For fiber-optic SFP modules, remove the dust plugs from the optical ports, and store them for later use. Caution Do not remove the dust plugs from the fiber-optic SFP module port or the rubber caps from the fiber-optic cable until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from contamination and ambient light. Step 6 Insert the cable connector into the SFP module: • For fiber-optic SFP modules, insert the LC or MT-RJ cable connector into the SFP module. • For copper SFP modules, insert the RJ-45 cable connector into the SFP module. Note When connecting to 1000BASE-T SFP modules, be sure to use a twisted four-pair, Category 5 cable. Removing SFP Modules from SFP Module Slots Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis. Step 2 Disconnect the cable from the SFP module, and insert a dust plug into the cable end. Note For reattachment, note which cable connector plug is send (TX) and which is receive (RX). Step 3 Unlock and remove the SFP module, as shown in Figure 2-15. If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed and you cannot use your index finger to open it, carefully use a small, flat-blade screwdriver or other long, narrow instrument to open the bale-clasp latch. Figure 2-15 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver 97929 40 41 42 43 44 45 46 47 48 47X Catalyst 3560 SERIES PoE-48 1 3 1 Bale clasp 48X 2 4 1 Step 4 Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot. OL-6337-07 Catalyst 3560 Switch Hardware Installation Guide 2-17