Clifford Remote Keyless Entry Owners Guide - Page 11
See How to Set Your Valet Code - how to program
View all Clifford Remote Keyless Entry manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Programming User-Selectable Features Your Remote Keyless Entry System Plus package allows you to set many of its features to your personal preferences. We have made the programming procedures very simple: to make a change, you just press the PlainView switch a few times. The system comes from the factory with all of its features pre-programmed as noted in the table below. To change any of these settings (turn them "OFF" to "ON," or vice-versa), just repeat the procedure: 1. Select the feature you wish to program from the table below. Note the number of momentary (spring-loaded) presses. 2. Turn your vehicle's ignition to its "ON" position, but do not start the engine. 3. Enter your valet code. 4. When the switch's LED turns on, immediately tap and release the momentary side of the switch the number of times indicated in the third column of programming table for the feature you have selected. a. If noted, perform the"Secondary action" listed in the fourth column of the programming table. 5. Return the switch to its center position and wait 3 seconds. You will see the switch's LED flash once to confirm the successful programming of the selected feature. or twice to confirm the successful programming of a new remote control button. 6. Turn off the ignition. 7. Repeat steps 1-6 for any other features or remote buttons you wish to program. Programming Table for User-Selectable Features Feature Factory setting # of momentary presses Secondary action Program completion confirmation Result Automatic Starter Off 4 Interrupt - 1 LED flash Change state from ON to OFF or vice-versa Automatic "passive" SelfLocking Off 5 Doors - 1 LED flash Change state from ON to OFF or vice-versa Valet Code "2" 6 See How to Set Your Valet Code on page 7. AutoLock/ AutoUnLock On 7 - 1 LED flash Change state from ON to OFF or vice-versa Add a New Remote to Channel 1 - (arm/disarm) 8 Press remote control button 1 within 10 seconds. 2 LED Flashes Button 1/channel 1 code of the new remote control has been memorized continued... 10