Clifford Remote Keyless Entry Owners Guide - Page 9
PlainView Coded Valet Switch LED Indicator, UltraSecure Coded Valet Mode - programming
View all Clifford Remote Keyless Entry manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PlainView Coded Valet Switch LED Indicator The LED status indicator in the switch is used to communicate the operational status of your Remote Keyless Entry System system: LED Condition Off On One Flash Two Flashes Flashing Meaning Doors are unlocked, you may enter the vehicle. System in valet or programming mode. Confirms successful programming of a system feature. Confirms successful programming of a remote control button. Doors are locked and system is protecting your vehicle. UltraSecure Coded Valet Mode Whenever your vehicle is to be washed, serviced or valet parked, you must put the system in valet mode if the automatic Starter Interrupt and SelfLock features are enabled. To enable valet mode 1. Turn the ignition switch to its "ON" position or start the engine. 2. Enter your secret valet code on the PlainView switch, then return the switch to its center position. 3. You now have 3 seconds to press the latched position (valet mode). Once you have entered valet mode, the system's LED will glow continually for ongoing visual confirmation of valet mode. Keyless entry in valet mode: Even if valet mode is enabled, you can still remotely control the convenience features. For instance, simply press button 1 as you normally would to unlock the doors. The doors will unlock (as indicated by one flash of the parking lights) and the interior lights will illuminate. Press button 1 again and the doors will lock (as indicated by two flashes of the parking lights), but the starter interrupt feature will not engage, so the vehicle may be driven by anyone with the car key. You can also use the remote control's other button to activate options such as a remote trunk release or remote engine starting. To exit valet mode 1. Turn the ignition switch to its "ON" position or start the engine. 2. Flick the switch back to its center position. The LED will turn off to confirm that the system is now in its normal operating mode. 8