Cobra 29 WX NW ST User Manual - Page 7

29 WX NW ST manual 3.3 6/15/99 2:53 PM Page 12 Operation Operation Note When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat recalibration steps. 5 While still holding down the mic button,set the S/RF SWR CAL switch to the SWR position, to read the SWR reading. 6 Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels. To Receive To Receive Selecting A Channel Selecting A Channel Note Switch to 9 (Emergency) or 19 (Information) for instant access to these channels. 1 Switch to NOR to select desired channel. S-Meter Swings proportionately to strength of incoming signal when receiving. S-Meter 1 Rotate the On/Off Volume knob clockwise the green RT/TX LED will be illuminated. 12 1 The S/RF-SWR-CAL switch must be in the S/RF position to read the meter. 13