Compaq 300 320 321 420 421 620 and 621 Notebook PC and 420 and 620 Notebook PC - Page 78
Heat sink, Remove the Phillips PM2.0×3.0 screw
![]() |
View all Compaq 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
3. Remove the Phillips PM2.0×3.0 screw (2) that secures the fan, and then remove the fan (3). Reverse this procedure to install the fan. Heat sink NOTE: The heat sink spare part kit includes replacement thermal material. Description Heat sink for use in computers with UMA graphics subsystems Heat sink for use in computers with discrete graphics subsystems Spare part number 605749-001 605750-001 Before removing the heat sink, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 56). 5. Remove the service door (see Service door on page 56). 6. Remove the fan (see Fan on page 69). Remove the heat sink on computers with UMA graphics subsystems: 1. Position the computer right-side up with the front facing you. 2. Following the sequence stamped into the heat sink, loosen the captive screws (1) and (2) around the processor. 70 Chapter 4 Removal and replacement procedures
![](/manual_guide/products/compaq-300-320-321-420-421-620-621-notebook-pc-420-620-notebook-pc-64663cb/78.png)