Compaq CRT Monitor s7500 Service Guide - Page 6

Ground Continuity Test

Get Compaq CRT Monitor s7500 PDF manuals and user guides View all Compaq CRT Monitor s7500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

HP S7500/MV7500/CV7500 d) Plug monitor power cord to the Hi Pot tester terminals. e) Turn on tester and watch the indicator or beeper. f) If the indicator lamp lighten, or beeper beeps, the test fails. 1-4 Ground Continuity Test 1. TestEquipment AC low ohm tester TOS-6100 or equivalent approved equipment. Note : The test equipment must be calibrated in regular period. 2. Test Setup a) Test duration : 3 seconds b) Set current limit at 25 A c) The grounding resistance must be less than 0.1 ohm. 3. Test Procedure a) Plug the monitor power cord to the tester terminals. b) Make sure all connections are well-contacted. c) Turn on monitor power and tester power. d) Press "Test" button. e) If green light shows up, means test OK. If red light shows up, means test fails. f) If the Tester has a digital display, the resistance value must not exceed 0.1 ohm. Note : Be sure not to touch the metal portion of the signal cable head during testing. Page 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Page 4
HP S7500/MV7500/CV7500
d)
Plug monitor power cord to the Hi Pot tester terminals.
e)
Turn on tester and watch the indicator or beeper.
f)
If the indicator lamp lighten, or beeper beeps, the test fails.
1-4 Ground Continuity Test
1.
Test Equipment
AC low ohm tester TOS-6100 or equivalent approved equipment.
Note : The test equipment must be calibrated in regular period.
2.
Test Setup
a)
Test duration : 3 seconds
b)
Set current limit at 25 A
c)
The grounding resistance must be less than 0.1 ohm.
3.
Test Procedure
a)
Plug the monitor power cord to the tester terminals.
b)
Make sure all connections are well-contacted.
c)
Turn on monitor power and tester power.
d)
Press “Test” button.
e)
If green light shows up, means test OK.
If red light shows up, means test fails.
f)
If the Tester has a digital display, the resistance value must not exceed 0.1 ohm.
Note : Be sure not to touch the metal portion of the signal cable head during testing.