Compaq M300 Compaq Armada M300 Series of Personal Computers Maintenance and Se - Page 28
Table 2-2, Fatal Error Messages
UPC - 743172791108
View all Compaq M300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Table 2-1 Continued Message Hard disk controller error Keyboard controller failure Keyboard failure No interrupts from Timer 0 ROM at xxxx (LENGTH yyyy) with nonzero checksum (zz) Time/Date corrupt - run SCU Hard disk xx failure (or error) Description Recommended Action The hard drive controller failed Check the drive parameters. Turn off to respond to the reset the system and check all related command. connections. The keyboard failed the self- Replace the system board. test command. The keyboard failed to respond Replace the keyboard. If the problem to the RESET ID command. persists, replace the system board. The periodic timer interrupt is Replace the system board. not occurring. An illegal adapter ROM was located at the specified address. Check the external adapter (such as a video card) to determine if it is causing the conflict. The time and date stored in the real time clock have been corrupted, possibly by a power loss. 1. Run Computer Setup. 2. If problems persists, replace system board. A failure or an error occurred 1. Run ScanDisk. when trying to access the hard 2. Check disk in DOS and drive. Windows 95. Fatal errors emit a beep and may display a FATAL message. Fatal errors indicate severe problems, such as a hardware failure. Fatal errors do not allow the system to resume. Some of the Fatal error beep codes are listed at the end of this section. Table 2-2 Fatal Error Messages Message Description CMOS RAM test failed A walking bit test of CMOS RAM location 0E (Hex) - 3F (Hex) failed. DMA controller faulty A sequential read/write of the transfer count and transfer address registers within the primary and secondary DMA controllers failed. Faulty DMA page registers A walking bit read/write of the 16 DMA controller page registers starting at location 80 Hex failed. Faulty refresh circuits A continuous read/write test of port 61h found that bit 4 (Refresh Detect) failed to toggle within an allotted amount of time. Interrupt controller failed A sequential read/write of various Interrupt Controller registers failed. ROM checksum incorrect A checksum of the ROM BIOS does not match the byte value at F000:FFFF. RAM error at location xxxx RAM error occurred during memory test. *Beep codes are defined in Table 2-3. Beep code 3 4 0 1 5 2 None Troubleshooting 2-5