Compaq M300 Compaq Armada M300 Series of Personal Computers Maintenance and Se - Page 89
Remove the system board., Lift up the rear edge of the system board.
UPC - 743172791108
View all Compaq M300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
11. Remove the two screws from the back of the computer that secures the system board to the base enclosure (Figure 5-28). 12. Remove the silver screw from the heat sink . 13. Remove the black screws from around the fan , around the USB port , and around the battery cable in the upper left of the board . 14. Lift up the rear edge of the system board. 15. Remove the system board. Figure 5-28. Removing the System Board Reverse the above procedure when installing the system board. Make sure to replace all components of the base enclosure into their appropriate locations. 5-30 Removal and Replacement Procedures
5-30
Removal and Replacement Procedures
11.
Remove the two screws from the back of the computer that secures the system board
to the base enclosure
(Figure 5-28).
12.
Remove the silver screw from the heat sink
.
13.
Remove the black screws from around the fan
, around the USB port
, and
around the battery cable in the upper left of the board
.
14.
Lift up the rear edge of the system board.
15.
Remove the system board.
Figure 5-28.
Removing the System Board
Reverse the above procedure when installing the system board.
Make sure to replace all
components of the base enclosure into their appropriate locations.