Compaq Presario V3500 Compaq Presario V3500 Notebook PC - Maintenance and Serv - Page 99
each time the fan/heat sink assembly is removed. Thermal pads and, and the processor
View all Compaq Presario V3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Remove the fan/heat assembly: 1. Disconnect the fan cable from the system board. 2. Turn the system board upside down, with the external monitor port toward you. 3. Loosen the four Phillips PM2.0×13.0 captive screws (1) that secure the fan/heat sink assembly to the system board. NOTE: Due to the adhesive quality of the thermal material located between the fan/heat sink assembly and system board components, it may be necessary to move the fan/heat sink assembly from side to side to detach the assembly. 4. Remove the fan/heat sink assembly (2). NOTE: The thermal material must be thoroughly cleaned from the surface of the fan/heat sink assembly (1) and the processor (2) each time the fan/heat sink assembly is removed. Thermal pads and thermal paste must be installed on all surfaces before the fan/heat sink assembly is reinstalled. Thermal pads and thermal paste are included with all fan/heat sink assembly, system board, and processor spare part kits. Component replacement procedures 91