Craftsman 17556 Operation Manual - Page 6

Size of Sanding Disc Size of Polishing Bonnet Horsepower 6 inches 6 inches 1/2 Rating Spindle Size No Load Speed 120 volts, 60 Hz, AC only, 4.5 amps. 1/2 inch 20 TPI 1,400/rain. & 1650/rain. _ ARNING: Always wear safety goggles or safety glasses with side shields when operating your sander/polisher. Failure to do so could result in dust, shavings, loose particles or foreign objects being thrown into your eyes, causing possible serious injury. KNOW YOUR SANDER/POLISHER Your sander/polisher is suitable for sanding with coarse, medium, and fine grit sanding discs. When used with the polishing bonnet supplied, it can also be used as a buffer or polisher. Before attempting to use any tool, familiarize yourself with all operating features and safety requirements. _IL ARNING: The double insulated system is intended to protect the user from shock resulting from a break in the tool's internal wiring. Observe all normal safety precautions related to avoiding electrical shock. TWO SPEED SWITCH See Figure 1. Your sander/polisher is equipped with a two speed switch trigger located in the rear handle. To turn ON, depress switch trigger, to turn OFF, release switch trigger. For low speed sanding or polishing, depress switch trigger halfway. For high speed sanding or polishing depress switch trigger all the way. Be sure switch trigger is in OFF position before connecting to power supply source. _IL ARNING: Do not allow familiarity with your tool to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. ___/" _LOCK-ON" SPANNER WRENCH XVi/_ POLISHING BONNET SANDING DISC (NOT INCLUDED) AUXILIARYHANDLE 6 Fig. 1