Craftsman 17965 Owners Manual - Page 5

Assembly (continued) Caster/Caster Foot Assembly 1. Remove the power assembly from the dust drum and set aside. 2. Turn the dust drum upside down on the floor. 3. Insert the caster feet into the bottom of drum, as shown (4 places). 4. Push on the caster foot until the foot is flush with bottom of the dust drum. 5. Insert the caster stem into the socket of the caster foot, as shown (4 places). 6. Push on the caster until the ball on the caster stem is inserted all the way into the socket. You will hear the ball snap into the socket and the caster will swivel easily when positioning is correct. 7. Turn the drum upright. Vac Assembly 1. Line up front (label) of power assembly with Vacuum port located on the front of the drum. NOTE: Power assembly must be aligned with drum for proper attachment. 2. Place power assembly on top of drum. 3. Be sure power assembly completely covers the top of the drum so leakage does not occur. Notch on power assembly must fit into slot on drum. Head Assembly , Power Head Assembly Notch lure Port Stem Caster Ball Caster Foot 4. Push down on top of handles to cause flexible locking tabs to hook onto the drum lip. 5. Make sure that the locking tabs are snapped into place to prevent the lid from coming off (see detail below). 6. To remove the power assembly, reverse above directions. Flexibme Locking Tab PummedOut \ Drum Flexible Locking Tab \ 5 Head Assembly Push Down •and Pull Out Flexible Locking Tab (located under match)