Craftsman 21221 Operation Manual - Page 131
the factory. However
View all Craftsman 21221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Fig. F 2 Fig. H 1 2 3 POWER CORD STORAGE CLIPS (FIG. G) For convenience and to prevent damage to the power cord when the miter saw is not in use or is in transportation, the slide carriage has two clips on the rear for cord storage. To assembly these clips: 1. Attach each power cord storage clips (2) to the rear of slide-bar seat with one mounting screws (1). I,A WARNING I To avoid injury, disconnect the plug from the power source before performing any adjustments or repair. NOTE: Your miter saw was adjusted at the factory. However, during shipment slight misalignment may have occurred. Check the following settings and adjust if necessary prior to using this miter saw. REMOVING AND INSTALLING THE TABLE INSERT (FIG. I) WARNINI G Fig. G 2 1 SAW BLADE WRENCH (FIG. H) For convenient storage and prevention of loss, there is a clip (1) located at the left rear foot of the base for storing the blade wrench (2). To avoid injury: • Always unplug the saw to avoid accidental starting. Remove all small pieces of material from the table cavity before performing any cuts. The table insert may be removed for this purpose, but always reattach the table insert prior to performing a cutting operation. • Do not start the sliding compound miter saw without checking for interference between the blade and table insert. Damage could result to the blade, table insert or turntable if blade strike occurs during the cutting operation. 19