Craftsman 21221 Operation Manual - Page 209
that the settings are interdependent
View all Craftsman 21221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
CUTTING BASE MOLDING (FIG. TT) Base moldings and many other moldings can be cut on a compound miter saw. The setup of the saw depends on molding characteristics and application, as shown. Perform practice cuts on scrap material to achieve best results: 1. Always make sure moldings rest firmly against fence and table. Use hold-down, crown molding vise or C-clamps, whenever possible, and place tape on the area being clamped to avoid marks. 2. Reduce splintering by taping the cut area prior to making the cut. Mark the cut line directly on the tape. 3. Splintering typically happens due to an incorrect blade application and thinness of the material. angles that, when added together, equal exactly 90 °. Most crown molding has a top rear angle (the section that fits flat against the ceiling) of 52°and a bottom rear angle (the section that fits flat against the wall) of 38 °. In order to accurately cut crown molding for a 90 ° inside or outside corner, lay the molding with its broad back surface flat on the saw table. When setting the bevel and miter angles for compound miters, remember that the settings are interdependent; changing one changes the other, as well. Fig. UU Fig. TT ne Miter saw table miter at 450, bevel at 0° _table miter at 0°, bevel at 450 Miter saw table Bevel/Miter Settings Fig. VV NOTE: Always perform a dry run cut so you can determine if the operation being attempted is possible before power is applied to the saw. CUTTING CROWN MOLDING (FIG. UU, VV) Settings for standard crown molding lying flat on compound miter saw table Inside corner \ ] OR ,-._1 WARNING I Your compound miter saw is suited for the difficult task of cutting crown molding. To fit properly, crown molding must be compound-mitered with extreme accuracy. The two surfaces on a piece of crown molding that fit flat against the ceiling and wall are at Outside corner Compound cut crown moldings NOTE: The chart below references a compound cut for crown molding ONLY WHEN THE ANGLE BETWEEN THE WALLS EQUALS 90 °. 41