Craftsman 21221 Operation Manual - Page 176
machine when finished
View all Craftsman 21221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
21. NEVER cut small pieces. If the workpiece being cut would cause your hand or fingers to be within 8-3/4 in. of the saw blade the workpiece is too small. 22. PROVIDE adequate support to the sides of the saw table for long work pieces. 23. NEVER use the miter saw in an area with flammable liquids or gases. 24. NEVER use solvents to clean plastic parts. Solvents could possibly dissolve or otherwise damage the material. 25. SHUT OFF the power before servicing or adjusting the tool. 26. DISCONNECT the saw from the power source and clean the machine when finished using. 27. MAKE SURE the work area is clean before leaving the machine. 28. SHOULD any part of your miter saw be missing, damaged, or fail in any way, or any electrical component fail to perform properly, lock the switch and remove the plug from the power supply outlet. Replace missing, damaged, or failed parts before resuming operation. 8