Craftsman 35182 Operation Manual - Page 9

m_WARNINGD:onoat ttemtpot throwordrop-stathrtechaisnaw. 5. Push the choke/fast idle lever in to the HALF CHOKE position. Doinsgowillputheoperataotrriskof CHOKE/FAST IDLE LEVER seriouinsjurdyuetolossofcontroolf thechaisnaw. IMPORTAPNOTINTTSOREMEMBER OFF Whenpullintghestarteror ped,onot / HALF usethefullextenotftheropeasthis / FULL cancausteheropetobreakD. onotlet / starteror pesnapbackH. oldthehan- dleandlettheroperewinsdlowly. Focr oldweathsetrartinsgt,arttheunit atFULCLHOKaEll;owtheenginteo warmupbeforsequeezitnhgethrottle trigger. 6. wCNiHOthtOTheEKpDc:Eohosonikotieota/nftati.edsmlteletpovt ceiurnttmheaFtUerLiaLl7. Pull the starter rope sharply with your right hand until the engine starts. Allow the engine to run for approximately 30 seconds. Then, squeeze STARTINACGOLDENGIN(oErwarm enginaefterunninogutoffuel) NOTEIn:thefollowinsgtepsw,hetnhe cfuhlolekxete/fnatihtds,eltecleovrreeirscthpt ruolltetslodeeutttointfhgoer and release the throttle trigger to allow engine to return to idle speed. STARTING A WARM ENGINE 1. Move ON/STOP switch to the ON startinisgsetautomatically. position. 2. Pull the choke/fast idle lever out to IGNITION SWITCH the FULL CHOKE position to set the fast idle, then push the lever in to the HALF CHOKE position. ON 3. Slowly press primer bulb 6 times. STOP 4. Using your right hand, pull starter rope handle with a controlled and steady motion until engine starts. 5. Squeeze and release throttle trigger to allow engine to return to idle Lever speed. DIFFICULT STARTING (or starting a 1. Move ON/STOP switch to the ON position. 2. Pull choke/fast idle lever out to the full extent (to the FULL CHOKE position). 3. Slowly press primer bulb 6 times. 4. This unit has the Sim--pulTM starting system. You do not have to pull the starter rope handle sharply or briskly. Using your right hand, pull starter rope handle 5 times with a controlled flooded engine) The engine may be flooded with too much fuel if it has not started after 10 pulls. Flooded engines can be cleared of excess fuel by pushing the choke/fast idle lever in completely (to the OFF CHOKE position) and then following the warm engine starting procedure listed above. Ensure the ON/STOP switch is in the ON position. and steady motion. Then, proceed Starting could require pulling the start- to the next step. er rope handle many times depending NOTE: If the engine sounds as if it is trying to start before the 5th pull, stop pulling and immediately proceed to the next on how badly the unit is flooded. If en- gine fails to start, refer to the TROUBLESHOOTING TABLE or call step. 1-800-235-5878.